LD-apparaten
Transistor pulse converter with voltage link for the generation of a three-phase, frequency and amplitude-variable output voltage from an AC mains. This unit in conjunction with the corresponding control unit is used to assemble a frequency converter or servo amplifier.
Technical description:
Technical description:
- Single-phase mains connection
- Variable link voltage due to fully controlled B2C rectifier bridge circuitry
- Three-phase inverter built with IGBT (insulated gate bipolar transistor)
- Maximum switching frequency 20 kHz, resulting in good approximation of sinusoidal current as well as low noise build-up in the machine
- Output short-circuit-proof, earth-fault-proof and switch-proof
- Interface for connection of the control unit (25-pin sub-D socket, TTL level)
- Each individual transistor can be switched on and off via the interface and is protected from damage with an interlocking device
- The respective activated IGBT's are displayed via LEDs
- Monitoring of the variable link voltage, temperature rise in machines and converter, excess currents in the rectifier and converter. Output of the switching status via interface and display via LEDs
- Integrated brake chopper
- Safe galvanic isolation (SELV) between the power component and the control unit
- Output currents are detected via Hall generators. Electrically separated output via interface
- Two-stage mains filter for the reduction of the line-bound interference
- Three-phase motor filter for the reduction of the edge steepness of the pulse voltages at the converter output to values < 250 V/µs
- Output voltage (UA): 3 x 0...230 V
- Output current (IA): max. 3 x 8 A
- Supply voltage: 200...240 V, 50/60 Hz via 4 mm safety sockets
- Maximum switching frequency 20 kHz
Inbegrepen apparaten
| Aantal | Arikel nr. | Apparaat |
|---|
Leveringsomvang
- 25-pin connection cable
Document delen
Hier kunt u een tijdelijke link aanmaken waarmee uw leerlingen het document kunnen openen zonder in te loggen.
dagen
This text is only displayed in LeyLab.
Students save their results as a file and send you this file in any way.
Here the feature is explained in a video.
Here the feature is explained in a video.
Copy the link and send it to your students in any way. Or show them the QR code. This way your students can easily open the document.